SS-152 Conformal Coating/Gel Product Description
SS-152 is a 1-part, heat cure silicone developed for conformal coating applications. SS-152 offers unprimed adhesion to metals and many plastics. Heated cures result in a tough and durable silicone conformal coating.
Product Features
Neutral Addition Cure
Fast heat cure
Self-leveling liquid
Fluoresces under UV light to enable coating inspection
Adhesion to metals and many plastics
Convenient 1 part system
Product Applications
Coating electronic assemblies
Industrial coating and sealing
Thin section potting & encapsulation
Chemical cure system
Platinum catalyzed, addition cure system.
Typical Properties
UNCURED
Specific Gravity 0.98
Color Clear
Solids 100 %
Shelf Life 12 MONTHS
Viscosity 600 cps.
Tack Free Time @ 110C 15 minutes
CURED - R.T.
Cured - 20 mins. @ 110C
Durometer, Shore A 10
Dielectric Strength
kv/mm 13
Dielectric Constant 2.4
Dissipation Factor
@ 1kHz 0.01
Thermal conductivity 0.0005
Application Methods
Apply by: pouring, dipping, brushing, flow-coat, spin-on or spraying.
Curing
Can be accomplished with heat to very rapid cures. Typical utilization involves dispensing in open air and oven, IR, or hot air curing.
Handling precautions
Avoid contact with tin cured RTV’s, sulphur compounds, azides, imides, latex rubber gloves, and amines as cure system can be deactivatedSolids
100% solids, contains no solvents
Adhesion
This product offers primerless adhesion to plastics, metals and typical substrates.
Service temperature
-65 to 250 C continuous
Limitations
Do not use product in solvent or fuel immersion applications. Allow to fully cure before putting assembly into service.
Packaging
SS-152 is available in 8 pound gallon cans, 40 lb. pails and 400 lb. drums. This product is also available in customer defined packaging upon request.
Handling and safety
For maximum shelf life, keep containers sealed when not in use. Keep out of the reach of children. Uncured sealant irritates eyes and skin. Refer to MSDS.
Shelf-life
Sealed containers are guaranteed for 6 months from the ship date when stored in a cool dry area below 70 F.
Applicable standards
Conforms to GM low volatility requirements.
Limited warranty
All recommendations, statements and technical data herein are based on tests
we believe to be reliable and correct, but accuracy and completeness of said
tests are not guaranteed and are not to be construed as warranty, either expressed
or applied. User shall rely on his own information and tests to determine
suitability of the product for the intended use, and the user assumes all
risk and liability resulting from the use of this product. Manufacturer’s
sole responsibility shall be to replace that portion of product of the manufacturer
proves to be defective. Manufacturer shall not be liable to the buyer or any
third party for injury, loss or damage directly or indirectly resulting from
the use of, or inability to use, the product.
Recommendations or statements other than those contained in a written agreement
signed by an officer of the manufacturer shall not be binding by the manufacturer.
This product has not been tested for, and is therefore not recommended for,
uses for which prolonged contact with mucous membranes, abraded skin, or blood
is intended; or for uses which implantation within the human body is intended.
** Customized versions available upon request **