SS-24 Product Description
SS-24 is an electrically conductive, moisture curing silicone RTV. SS-24
is a 1-Part silicone that when applied to the substrate allows handling of
the assembly after 1 hour. When cured, the elastomer resists weathering, ozone,
moisture, UV and high temperature. SS-24 works well in manual and automatic
dispensing equipment.
Product Features
- Fast R.T. cure
- Thixotropic paste
- High temperature resistant
- Non-corrosive
Typical Applications
- Form in place gaskets
- Electrically conductive sealant
- EMI/RFI silicone shielding
Chemical cure system
Oxime cure system
Typical Properties
Colors: dark gray
Viscosity, cps 500,000
Specific Gravity 2.09
Consistency : thixotropic paste
Working time, mins. @ R.T.: 15
Tack Free Time, mins. @ R.T.: 60
Application Rate, 90 PSI, g/min. 400
Cure time 24 Hrs. @ R.T.
Durometer, Shore A 40-50
Tensile Strength 289 PSI
Volume resistivity, Ohms/cm 0.09
Conductive filler nickel/graphite
Curing
Cure speed can be accelerated with increased humidity and heat to very rapid cure times. Typical utilization involves dispensing in open air and after exposure to ambient humidity, a room temperature cured rubber with electrically conductive properties is formed.
Method of Application
Dispense sealant onto part. Mate parts, and be sure not to squeeze all of
the product out of flange assembly. Allow to cure.
Solids
98% solids
Packaging
SS-24 is available in 10.3 oz. cartridges and 40 lb. pails. This product is also available in customer defined packaging sizes upon request
Adhesion
Primerless adhesion to most metals and typical substrates.
Service temperature
-65 to 260C
Limitations
Allow to fully cure before putting assembly into service. Ensure enough product remains between flanges to be effective in an assembly.
Handling and safety
For maximum shelf life, keep containers sealed when not in use. Keep out of the reach of children. Uncured sealant irritates eyes and skin. Refer to MSDS.
Shelf-life
Sealed containers are guaranteed for 12 months from the ship date when stored in a cool dry area below 70 F.
Limited warranty
All recommendations, statements and technical data herein are based on tests
we believe to be reliable and correct, but accuracy and completeness of said
tests are not guaranteed and are not to be construed as warranty, either expressed
or applied. User shall rely on his own information and tests to determine
suitability of the product for the intended use, and the user assumes all
risk and liability resulting from the use of this product. Manufacturer’s
sole responsibility shall be to replace that portion of product of the manufacturer
proves to be defective. Manufacturer shall not be liable to the buyer or any
third party for injury, loss or damage directly or indirectly resulting from
the use of, or inability to use, the product.
Recommendations or statements other than those contained in a written agreement
signed by an officer of the manufacturer shall not be binding by the manufacturer.
This product has not been tested for, and is therefore not recommended for,
uses for which prolonged contact with mucous membranes, abraded skin, or blood
is intended; or for uses which implantation within the human body is intended.
** Customized versions available upon request **