SS-2612 Product Description
SS-2612 is an electrically conductive, room temperature curing silicone RTV. SS-2612
is a 2-Part silicone that when applied to the substrate allows handling of
the assembly after 1 hour. When cured, the elastomer resists weathering, ozone,
moisture, UV and high temperature. SS-2612 works well in manual and automatic
dispensing equipment.
Product Features
Very high electrical conductivity
R.T. Cure or Fast Heat Cure
Self-leveling liquid
1:1 mix ratio
High temperature resistant
Non-corrosive addition cure
Typical Applications
Conductive Encapsulation or Lamination
EMI/RFI silicone shielding
Electrically conductive sealant
Thermally conductive sealant
Color: Silver-Tan
(custom colors available upon request)
2-Part Electrically Conductive Silicone RTV
Typical Properties
Viscosity, cps 300,000
Specific Gravity 3.06
Consistency : thick liquid
Working time, mins. @ R.T.: 15
Tack Free Time, mins. @ R.T.: 30
Cure Time: 48hrs. @ R.T. or 15min. @ 150C
Application Rate, 90 PSI, g/min. 400
3mm orifice @ 0.6 MPa
Cure time 24hrs.@R.T.
Durometer, Shore A 70
Volume Resistivity, Ohms/cm 0.005
Conductive Filler: Silver
Method of Application
Dispense sealant onto part. Mate parts, and be sure not to squeeze all of
the product out of flange assembly. Allow to cure.
Chemical cure system
Addition cure system
Curing
Cure speed can be accelerated with heat to very rapid cure times
Packaging
SS-2612 is available in 50 and 400ml dual syringes as well as 1,2 and 5 gallon pail kits.. This product is
also available in customer defined packaging sizes upon request.
Solids
98% solids
Adhesion
Primerless adhesion to most metals and typical substrates.
Service temperature
-65 to 260C
Limitations
Allow to fully cure before putting assembly into service. Ensure enough product
remains between flanges to be effective in an assembly.
Handling and safety
For maximum shelf life, keep containers sealed when not in use. Keep out of
the reach of children. Uncured sealant irritates eyes and skin. Refer to MSDS.
Shelf-life
Sealed containers are guaranteed for 6 months from the ship date when stored
in a cool dry area below 70 F.
Limited warranty
All recommendations, statements and technical data herein are based on tests
we believe to be reliable and correct, but accuracy and completeness of said
tests are not guaranteed and are not to be construed as warranty, either expressed
or implied. User shall rely on his own information and tests to determine
suitability of the product for the intended use, and the user assumes all
risk and liability resulting from the use of this product. Manufacturer’s
sole responsibility shall be to replace that portion of product of the manufacturer
proves to be defective. Manufacturer shall not be liable to the buyer or any
third party for injury, loss or damage directly or indirectly resulting from
the use of, or inability to use, the product.
Recommendations or statements other than those contained in a written agreement
signed by an officer of the manufacturer shall not be binding by the manufacturer.
This product has not been tested for, and is therefore not recommended for,
uses for which prolonged contact with mucous membranes, abraded skin, or blood
is intended; or for uses which implantation within the human body is intended.
** Customized versions available upon request **