SS-3045 Product Description
Download PDF
SS-3045 is a heat curing, high strength silicone adhesive rubber developed for bonding applications requiring fast development of physical properties and excellent adhesion. SS-3045 is a 1-part silicone that that when applied to the substrate and thermally cured allows handling of the bonded assembly within minutes. SS-3045 works well in manual and automatic dispensing equipment.
Product Features
- 15 minute cure @ 150C
- Excellent Unprimed Adhesion to Metals and Glass
- Thixotropic Paste
- Temperature range –45 to 260C
Product Applications
- Assembly Line Adhesive
- Form in Place Gaskets
- Adhesive Sealant
Chemical cure system
Platinum catalyzed, addition cure system.
UNCURED
Specific Gravity 1.08
Color translucent
Solids 100 %
Viscosity 500,000 cps.
Tack Free Time @ 150C 15 minutes
Working Time @ R.T. >7 days
CURED 15 min @ 150C
Tensile Strength, PSI 600
Elongation, % 450
Durometer, Shore A 30
Thermal conductivity 0.0005
Coefficient of Thermal Expansion
20 x 10-5
Dissipation Factor 0.001
Dielectric Constant 2.8
Dielectric Strength V/mil >500
Curing
Can be accomplished with heat to very rapid cures. Typical utilization involves dispensing in open air and oven, IR, or hot air curing.
Handling precautions
Avoid contact with tin cured RTV’s, sulphur compounds, azides, imides, latex rubber gloves, and amines as cure system can be deactivated
Solids
100% solids, contains no solvents
Adhesion
This product offers primerless adhesion to plastics, metals and typical substrates.
Service temperature
-45 to 260 C continuous
Limitations
Do not use product in solvent or fuel immersion applications. Allow to fully cure before putting assembly into service.
Packaging
SS-3045 is available in 10.3oz. cartridges, 40 lb. pails and 400 lb. drums. This product is also available in customer defined packaging upon request.
Handling and safety
For maximum shelf life, keep containers sealed when not in use. Keep out of the reach of children. Uncured sealant irritates eyes and skin. Refer to MSDS.
Shelf-life
Sealed containers are guaranteed for 6 months from the ship date when stored in a cool dry area below 70 F.
Applicable standards
Conforms to GM low volatility requirements.
Limited warranty
All recommendations, statements and technical data herein are based on tests
we believe to be reliable and correct, but accuracy and completeness of said
tests are not guaranteed and are not to be construed as warranty, either expressed
or applied. User shall rely on his own information and tests to determine
suitability of the product for the intended use, and the user assumes all
risk and liability resulting from the use of this product. Manufacturer’s
sole responsibility shall be to replace that portion of product of the manufacturer
proves to be defective. Manufacturer shall not be liable to the buyer or any
third party for injury, loss or damage directly or indirectly resulting from
the use of, or inability to use, the product.
Recommendations or statements other than those contained in a written agreement
signed by an officer of the manufacturer shall not be binding by the manufacturer.
This product has not been tested for, and is therefore not recommended for,
uses for which prolonged contact with mucous membranes, abraded skin, or blood
is intended; or for uses which implantation within the human body is intended.