SS-55L Product Description
Download PDF
SS-55L is a high temperature gasket dressing. Developed as a non-running gel
sealant, this product provides high-tack properties to gaskets. SS-55L fills
microscopic voids between the gasket and clamping surfaces. Unlike competitive
offerings, SS-55L will not lose physical properties when subjected to extreme
temperatures.
Product Features
Non-hardening
High temperature >600F
Resists engine fluids
Non-organic
Considered safe in California (solvent free)
Color: Blue
(custom colors available upon request)
Typical Applications
Gearbox assemblies
Oil Pans
Transmission Pans
High Temperature Gasket Dressing
Typical Properties
Specific Gravity 0.90
Appearance thixotropic gel
Odor none
Solids 100%
VOC’s <1
Flashpoint 600F
Method of Application
Dispense dressing onto gasket and flange surface. Install component and tighten
fasteners to the manufacturer’s torque specifications, thus sealing
all surface irregularities with the fastener clamping force.
Chemical cure system
Oxime cure system
Solids
98% solids , contains no solvents.
Service temperature
-45 to 260 C
Limitations
Allow to fully cure before putting assembly into service. Ensure enough product
remains between flanges to be effective in an assembly.
Handling and safety
For maximum shelf life, keep containers sealed when not in use. Keep out of
the reach of children. Uncured sealant irritates eyes and skin. Refer to MSDS.
Packaging
SS-55L is available in 8, 40, and 400 lb containers.
Shelf-life
Sealed containers are guaranteed for 1 year from the ship date when stored
in a cool dry area below 70 F.
Applicable standards
Conforms to GM 9985675 and GM low volatility requirements.
Limited warranty
All recommendations, statements and technical data herein are based on tests
we believe to be reliable and correct, but accuracy and completeness of said
tests are not guaranteed and are not to be construed as warranty, either expressed
or applied. User shall rely on his own information and tests to determine
suitability of the product for the intended use, and the user assumes all
risk and liability resulting from the use of this product. Manufacturer’s
sole responsibility shall be to replace that portion of product of the manufacturer
proves to be defective. Manufacturer shall not be liable to the buyer or any
third party for injury, loss or damage directly or indirectly resulting from
the use of, or inability to use, the product.
Recommendations or statements other than those contained in a written agreement
signed by an officer of the manufacturer shall not be binding by the manufacturer.
This product has not been tested for, and is therefore not recommended for,
uses for which prolonged contact with mucous membranes, abraded skin, or blood
is intended; or for uses which implantation within the human body is intended.